Experimental Details
Expectations. This information helps us to
offer advice on experimental design.
Acquisition Parameters. Please enter the
data acquisition parameters based on your knowledge of the sample.
Scan rate (normally 60 °C/hr).
Start Temperature (°C).
End Temperature (°C).
Other instructions.
Sample Guidelines & Information.
We accept NO radioactive samples.
The minimal guidelines below must be followed to ensure an accurate estimate
of properties for molecular transitions arising from temperature change.
- Sample volume at least 1.5 ml.
- For protein solutions, the lowest concentration is 0.2 mg/ml. Some proteins
and other macromolecules may have to be studied at higher concentrations.
- Dialyse the sample solution exhaustively against buffer.
- If the solution contains visible particles, they should be filtered out.
- If possible, the concentration and pH should be determined on the final solution.
- Provide at least 20 ml of buffer.
- DTT should be avoided and replaced by b-mercaptoethanol or TCEP.
Sample name and composition.
Your sample ID number.
Molecular weight.
Volume (ml)
Buffer components. Include concentrations & pH
Buffer volume (ml).
When will the sample will be ready for us?
Explain any special handling for your sample.
You can print the next verification page after you submit your request. We
will contact you to schedule your request. We will contact you to schedule your
request. If you do not hear from us within 48 hours, please contact
us.
|
